Filter
Top Products
Page 50
UTY4422-002 Page 50 of 72
B.4.4 Aspect Ratio Settings
A S P E C T R A T I O M O D E :
x x x x
ASPECT RATIO MODE: xxxx is either 4:3, 16:9, or AUTO. Press <SELECT> to enable
changes to the aspect ratio. Press <SELECT> again to lock in the aspect ratio shown on the
LCD.
B.4.5 Audio Settings
Similar to SETAUDIO terminal command.
A U D I O S E T T I N G S :
P r e s s < S E L E C T >
Moves user to 3rd level screens under “AUDIO SETTINGS.”
Shown for each installed audio channel. One screen is shown for each channel, either 1 or 2.
P O R T # : n R O U T E : x
L A N G : y y y A T T E N : z z
PORT: n is the ASI Port number, 1 or 2.
ROUTE: x is the routing, either “S” for normal stereo, “R” for reversed stereo, “1” for original
Left to both, and “2” for original Right to both.
LANG: yyy is the character name for audio program, any set of three alphanumeric characters.
Alternately, it may be ‘*’ which is wildcard. This forces the audio program with the lowest
unselected PID (in PMT) associated with the selected program number (service) to be routed to
this output. Edit session begins on left-most character. Up/down arrow scrolls through all
alphanumerics as well as ‘*’.
ATTEN: zz is audio attenuation control level, and can be set between ‘0’ and ’14.’
R E T U R N :
P r e s s < S E L E C T >
Returns to 2nd level screens under “HARDWARE SETUP.”
B.4.6 Serial Ports
S E R I A L P O R T S
P r e s s < S E L E C T >
Moves user to 3rd level screens under “SERIAL PORTS.”
S E R I A L 1 : D E V I C E
S E R I A L 2 : D E V I C E
DEVICE: either PRINTER, TERMINAL, MODEM, OR AUX. DATA. See Section 3.7
(Page 34) for restrictions on DEVICE assignments.