Filter
Top Products
13
After the software has been loaded, you are ready to proceed to the next step.
If you are installing the HD Satellite Interface as an add-on and have not
yet installed the data cable and interface, return to section 3.2 Route Cables.
If you have already installed the Satellite Interface and data cable, you must power
cycle the interface after the software update has been made for proper communi-
cation with satellite antenna.
3.8 Connect Data Cable to Electronics Board and Replace Dome
If you have already installed power/data cable, you are ready to nish the rooftop
installation.
After disconnecting the clone box data cable, plug in the modular data cable from the
power/data cable into the modular connection on the electronics board. See Figure 3.10.
Figure 3.10
Note: Movin’ View board shown. RoadTrip board will be slightly
different
Verify that all connections have been made inside dome and that all cables have been tied
down to base using cable ties. Replace dome using 8 dome screws.