Filter
Top Products
12 Installation
MAN0131 (Rev. 12/23/2005)
CUB CADET 475 LOADER
Remove Hydraulic Fittings
Use thread sealant on pipe threads. Be careful not to
use excess sealant that could enter hydraulic system.
NOTE: Some fittings in hose kit will not be used for
this installation.
1. Remove female quick coupler (C), dust plug, and
elbow (B) from the RETURN port (T) on the
hydraulic manifold. Leave adapter (E) in place.
See Figure 14.
2. Remove hose (A) from elbow in the PRESSURE
port (P) on the hydraulic manifold.
3. Disconnect hose (D) from PBY port on the
hydraulic manifold.
Figure 14. 475 Loader Hydraulic Fitting
Loader Fittings
A. -------- Hose, 28” x 3/8 NPTM x 3/8 NPTM
B. -------- Elbow, 3/8 NPTM x 3/8 NPTM
C. ------- Quick coupler, male 3/8
D. -------- Hose, 40” x 3/8 NPTM x 1/2 NPTM
E. -------- Adapter, 3/8 BSPTM x 3/8 NPTF
Install Hydraulic Fittings
1. Rotate elbow (B) and male quick coupler (C) in
the PBY port (N) to point to the rear. See Figure
15.
2. Attach tee (5) to adapter (E) and point center port
to the front.
3. Attach elbow (4) and male quick coupler (3) to the
end of tee (5). Point elbow and quick coupler to
the rear.
4. Attach elbow (4) and female quick coupler (2) to
the center port of tee (5). Point quick coupler
upward.
5. Rotate elbow (F) in the PRESSURE port (P) to
point to the rear.
6. Attach female quick coupler (2) to hose (8).
Attach hose (8) to elbow (F).
Figure 15. Hydraulic Fitting Installation
CD4482-1
PRESSURE
RETURN
PBY
A
B
C
D
E
CD5941A-4
P
T
N
2
4
2
3
5
4
8
B
C
E
F
Loader Fittings
B. -------- Elbow, 3/8 NPTM x 3/8 NPTM
C. ------- Quick coupler, male 3/8
E. -------- Adapter, 3/8 BSPTM x 3/8 NPTF
F. -------- Elbow, 3/8 BSPTM x 3/8 NPTM
Hose Kit Fittings
2. 64299 Quick coupler, female
3. 64300 Quick coupler, male 3/8
4. 66367 Elbow, 3/8 NPTM x 3/8 NPTM 90°
5. 66368 Tee, 3/8 NPT
8. 360001 Hose, 28” x 3/8 NPTM x 3/8 NPTM