Filter
Top Products
8 Installation
MAN0131 (Rev. 12/23/2005)
HYDRAULIC INSTALLATION
Keep hands and body away from pressurized
lines. Use paper or cardboard, not hands or other
body parts to check for leaks. Wear safety goggles.
Hydraulic fluid under pressure can easily penetrate
skin and will cause serious injury or death.
Make sure that all operating and service person-
nel know that if hydraulic fluid penetrates skin, it
must be surgically removed as soon as possible by a
doctor familiar with this form of injury or gangrene,
serious injury, or death will result. CONTACT A PHY-
SICIAN IMMEDIATELY IF FLUID ENTERS SKIN OR
EYES. DO NOT DELAY.
Make sure all hydraulic hoses, fittings, and valves
are in good condition and not leaking before starting
power unit or using equipment. Check and route
hoses carefully to prevent damage. Hoses must not
be twisted, bent sharply, kinked, frayed, pinched, or
come into contact with any moving parts. Operate
moveable components through full operational
range to check clearances. Replace any damaged
hoses immediately.
9261 PUMP KIT INSTALLATION
Install Pump Kit
NOTE: For complete information on pump kit installa-
tion, consult the Woods BH6500/7500 backhoe oper-
ators manual.
1. Attach pump mounting bracket (2) to pump
assembly with the offset toward the pump as
shown in Figure 6.
2. Secure with cap screw (5) and lock nut (3) as
shown.
3. Torque hardware to 85 lbs-ft.
NOTE: The pump mounting bracket is designed
to slip over the tractor drawbar and prevent the
pump from rotating. Trim the bracket flush with
the bottom of the tractor drawbar if desired.
1. 37909 Pump
2. 31234 Pump mounting bracket
3. 765 1/2 NC Hex lock nut
4. ——— Tractor drawbar bracket
5. 3379 1/2 NC x 1-1/2 Cap screw
6. ——— Tractor PTO shaft
Figure 6. Pump Bracket Installation
Remove
Excess
BD3260