Filter
Top Products
Installation 5
MAN0131 (Rev. 12/23/2005)
BACKHOE SUB-FRAME INSTALLATION
Tractor Preparation
■ Only use 1002899 Sub-Frame Mounting Kit for
mounting Woods BH6500 Backhoes on Cub
Cadet
®
7000, 7192, 7194, 7195, 7200, 7205 tractors
and Mahindra 2015 tractors equipped with Woods
1006, Cub Cadet 475, or Mahindra ML104 Loaders.
Any other use or modification of this mounting kit
may result in serious injury or death.
For installing this sub-frame, references to right, left,
forward and rearward directions are determined from
the operator’s position in the tractor seat.
Do not install 1002899 sub-frame on tractor without a
Woods, Cub Cadet, or Mahindra loader mount
attached.
Refer to the Woods BH6500/7500 Backhoe Opera-
tor’s Manual for backhoe assembly instructions.
1. Remove the tractor top link, 3-point lower lift
arms, and anti-sway links. Store these parts for
reinstallation when backhoe and sub-frame are
removed and 3-point hitch is required.
2. Disconnect and remove front end loader from
tractor, using instructions in the loader manual.
Do not remove loader mounting frame.
3. If attached, disconnect and remove mid-mount
mower from tractor, using instructions in mower
manual.
4. If attached, remove mower rear rockshaft lift
mechanism from tractor.
5. Place a jack under the tractor transmission hous-
ing and raise just enough to support the tractor.
Do not raise tractor off the ground. Supporting the
transmission prevents leakage.
6. Remove cap screws (A) and lock washers (B)
from both tractor lift arm brackets (C) on rear axle
housing (D). Save hardware. See Figure 1.
7. Remove two additional axle housing cap screws
(E) above the lift arm brackets as shown.
Figure 1. Remove LIft Arm Brackets and Hardware
A. * M10 x 85mm Cap screw
B. * Lock washer
C. * Tractor lift arm bracket
D. * Rear axle housing
E. * M10 x 50mm Cap screw
* Tractor Parts
B
C
A
D
A
A
CD4168C
E
As a valued customer, Woods appreciates your comments. Once sub-frame and hydrau-
lic hoses have been installed, please take a few minutes to complete the Sub-Frame
Mount Evaluation sheet that was supplied with your sub-frame. Your comments will help
us continue to bring you quality products.