Woods Equipment BH6500 TV Mount User Manual


 
Installation 13
PN-59756 (Rev. 4/9/01)
SUB-FRAME & BACKHOE TO TRACTOR
Mount Sub-Frame & Backhoe to Tractor
n The sub-frame mount is designed to provide
secure mounting and adequate operator clear-
ance when properly installed. Check clearance
dimensions shown in figure 1 to be sure you have
installed sub-frame correctly. Follow all mounting
instructions in this manual. Do not operate back-
hoe unless there is adequate clearance. Failure to
check and comply with these instructions may
result in serious injury or death.
n The only time the backhoe may be operated
from a position other than the operator seat is
during backhoe attachment and removal. Opera-
tor must
Read Sub-Frame Mounting Kit Manual
instructions on attaching and removing back-
hoe and use extreme care
Always stand between rear tire and back-
hoe stabilizer arms or along side of tractor to
avoid being trapped should the boom swing
control be accidentally activated.
n Remove seat and upper support assembly
before installing or removing backhoe from trac-
tor. Failure to comply may result in equipment fail-
ure and/or personal injury.
1.
Remove the backhoe seat assembly.
2. Place sub-frame flat on a hard level surface.
3. Back tractor over the sub-frame and center
between the tractor rear tires. Position tractor so that
the hydraulic system can be connected. Shut off trac-
tor, set brake, remove key.
4. Install pump (see Connect Hydraulic System sec-
tion, next page).
5. Start tractor.
NOTE: You will use the backhoe hydraulics to maneu-
ver the sub-frame into position. Use care in this pro-
cedure to avoid being trapped between tractor and
backhoe or between backhoe parts.
6. Raise rear of sub-frame up by lowering stabilizers
and boom section until even with channels of rear
mount.
7. Drive tractor back so that crosstube slides into
channel. Shut off tractor, set brake, remove key.
8. Fasten sub-frame in place by placing clevis pins
into channel holes and secure with safety pins.
9. With the tractor engine off, relieve pressure in the
backhoe boom and stabilizers to raise sub-frame into
front hanger.
10. Install bent pin and klik pin in front hanger mount.
11. Reinstall seat.
12. Start tractor and put backhoe into transport posi-
tion (see backhoe operators manual).
NOTE: Install swing lock before transporting.