Installation 7
PN-59756 (Rev. 4/9/01)
SUB-FRAME INSTALLATION Cont’d
Install Mid-mount Bracket
1. Install mid-mount bracket (3) to underside of
transmission housing, using cap screws (23) and
washers (29) as shown in Figure 4.
NOTE: Bracket has a small notch, to be positioned
on the left side the the tractor.
NOTE: Leave hardware loose.
2. The mounting kit will limit access for two grease
fittings on the clutch and brake pedals. Replace 6mm
straight grease fitting with a 90-degree grease fitting
(not supplied in reinforcement kit).
3. 1000590 Mid-mount bracket
23. 62584 M12–1.75P x 35mm Cap screw
29. 57811 1/2 Extra thick flat washer
Figure 4 Mid-mount Bracket Installed
2923
GREASE FITTINGS
Modify Loader Mounts
For tractors equipped with New Holland 7106
Loader
1. Position right and left reinforcement brackets (5,
6) on tractor.
2. Hand tighten appropriate hardware (refer to Fig-
ure 6) to hold brackets in place.
3. An additional hole will need to be drilled into each
side of the New Holland loader rear mount (refer to
Figure 5):
a. Using the left reinforcement bracket as a tem-
plate, match up existing two holes on the loader
rear mount and mark location for new hole.
b. Remove the reinforcement bracket.
c. Drill a 17/32” diameter hole as shown. This
can be done with the loader mount installed if a
right angle drill is used.
d. Repeat for right mount.
Figure 5 Additional Hole Drilled for 7106 Loader
(Left side shown)
17/32” HOLE