Filter
Top Products
Installation 5
PN-59756 (Rev. 4/9/01)
SUB-FRAME INSTALLATION Cont’d
n If you do not understand any part of this man-
ual and need assistance, see your dealer.
n Always wear relatively tight and belted clothing
to avoid entanglement in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and
head.
* Operator’s seat must be located in the lowest and
most forward position to obtain 40” minimum radius.
Figure 1 Sub-Frame Clearance
TRACTOR PREPARATION
1. Refer to the WOODS 6500/7500 Backhoe Opera-
tor’s Manual for backhoe assembly instructions.
NOTE: For installing this sub-frame, reference to
right, left, forward and rearward directions are deter-
mined from the operator’s position in the tractor seat.
2. Remove the tractor top link, 3-point lower lift
arms, and lower hitch pins. Store these parts for rein-
stallation when backhoe and sub-frame are removed
and when 3-point hitch is required.
3. Disconnect and remove the front end loader from
the tractor using instructions in loader manual. Do not
remove loader mounting brackets.
NOTE: Leave all hardware loose until sub-frame
weldment has been fit up.
CAUTION