Zenith L20V54S Flat Panel Television User Manual


 
Cable Service Hookup
PAGE 10
Locate the Antenna/Cable jack on the
back of the TV.
Connect the cable wire to the
Antenna/Cable jack according to one
of the diagrams to the right.
After all connections are complete,
plug in the TV. The LCD TV/Monitor is
designed to operate on AC power.
1
2
3
Connect cable service to the LCD TV/Monitor.
Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire sticking
through the middle, and it screws onto the threaded jack on the back of the TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
on one end and a round opening with a wire sticking out on the other end.
300 TO 75 OHM
ADAPTER
For cable box operation, leave the television
tuned to channel three or four and use the
cable box to change channels.
SPEAKER SWITCH
PILLOW
SPEAKER
NORMAL
SPEAKER
FUTURE
USE
RS-232C
SELECT
CONTROL NORMAL
(DTV)
SPEAKER SWITCH
PILLOW
SPEAKER
NORMAL
SPEAKER
FUTURE
USE
RS-232C
SELECT
CONTROL NORMAL
(DTV)
Connections Panel
Cable TV
Wall Jack
RF Coaxial
Wire (75 ohm)
Cable TV
Wall Jack
Coaxial Wire RF
(75 ohm)
Connections Panel