Filter
Top Products
Clone Programmer Learning Setup
PAGE 43
Learning the Master TV Setup
Instructions for the Clone Programmer to Learn the Master L20V54S Setup.
Use MPI Cable to Connect LT2002 Clone Programmer to
Master L20V54S MPI Port
If there is a good connection, “THE CLONE HAS CONTROL OF TV” message
will appear. Press any key on the Installer remote.
Learn Setup from Master L20V54S
Press 1 to select the “LEARN FROM TV” option, then press ON/OFF,
POWER, or ENTER to go to the Memory Bank Selection Menu. Pick the
Memory ”Bank” you want to store the master L20V54S’s setup in by
pressing either Channel key repeatedly to choose Memory 1, 2 or 3.
(If you choose a Memory “Bank” that has a master device’s setup
programmed into it, that setup will be overwritten by the new master
L20V54S’s setup.) Once the Clone memory bank is selected, press
ON/OFF, POWER, or ENTER. The Clone memory bank you have selected
will be shown. Press ON/OFF or POWER to begin copying the master
L20V54S’s setup.
Set the Clock (Optional)
Set the time on a Master TV’s Clock. (If the time has already been
copied from a TV into the Clone programmer, you can set a master
TV’s clock by copying the time from the Clone programmer.) The
Clone Programmer can copy the current time to both a master TV and
to the Clone’s internal clock; accurate to within one minute. (Another
reason that the Clone programmer should be equipped with fresh,
high-quality alkaline batteries, is for it to keep the time as accurately
as possible.)
Since the Clone Programmer’s time cannot be set directly, the current
time needs to be copied from a Zenith/LG TV equipped with M.P.I.
input capability.
After the time is copied to the Clone programmer, the current time
can then be transferred to another TV. (This can be a master TV, or
another TV which has already had the features set up.)
*Note: When using the clone programmer for teaching or learning,
be sure that the heartbeat pattern is shown on the LEDs. Both learning and
teaching should take about 45 or more seconds depending on the complexity
of the master setup. While the clone is functioning, do not move it or otherwise
disturb the clone or wiring connections. If the clone finishes the function in less than
45 seconds, redo the function again. Press the reset button if the clone does not act
normally.
LT2002 Clone Programmer Communication Problems
• A slow flashing green light indicates there are communication
problems between the L20V54S and the LT2002 clone
programmer. If this is the case, check for a damaged cable,
poor contacts, or other connection troubles.
• If the status indicator is red, the programmer batteries are
low and should be replaced. Install 4 high-quality alkaline AA
batteries.
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION XX
THE TV IS VERSION XX
THE SW IS REVISION XX
CLONE CLOCK= XX:XX
TV CLOCK= XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.
This menu should appear by itself after the
LT2002 is connected to the L20V54S MPI port.
CLONE SELECTION MENU
(1) LEARN FROM TV
(2) TEACH TO TV
(3) SET CLONE CLOCK FROM TV
(4) SET TV CLOCK FROM CLONE
(5) DISPLAY TV SETUP
(6) DISPLAY CLONE SETUP
- TO CHANGE MENU ITEMS, PRESS
CHANNEL KEYS OR DIGITS.
- TO EXECUTE ITEM, PRESS ON/OFF,
POWER, OR ENTER