Filter
Top Products
Chapter 1 Introducing the STB
STB-1001S2 User’s Guide
19
Figure 3 Rear Panel Connections
1.4 Resetting the STB
To reset the STB to its factory defaults, use the System Setup menu (see Section 2.2.4 on page
24).
Table 2 Rear Panel Connections
LABEL DESCRIPTION
ON/OFF Use this switch to turn the STB on or off.
POWER Connect this port to a suitable power supply using the provided adaptor.
USB Use this port to connect to a USB keyboard (not supplied).
LAN Use this Ethernet port to connect the STB to your Internet access device or
network.
S/PDIF Use this port to connect the STB to an S/PDIF (Sony / Philips Digital Interface
Format) audio device.
CVBS Use this composite video RCA connector to connect the STB to your TV’s
analog video input (usually colored yellow).
The composite video connector does not carry audio. You must also connect
your TV to one of the STB’s audio connectors.
L, R Use these to connect the STB to your audio device’s analog audio inputs.
L: The white RCA connector carries the stereo audio signal (left channel).
R: The red RCA connector carries the stereo audio signal (right channel).