AP-2
Double-feed frequently
occurs.
Do the documents qualify the "Docu-
ment Quality" and the "Double-feed
Detection Conditions" in the chapter 6
of the fi-4530C Operator’s Guide?
Use the documents that qualify the "Document
Quality" and the "Double-feed Detection Con-
ditions" in the chapter 6 of the fi-4530C Opera-
tor’s Guide.
Are the documents set properly in the
ADF paper chute?
Fan the documents before scanning. Correctly
align the document stack and load them on the
ADF paper chute. Refer to "2.1 Installing the
Scanner" on page 3 for details.
Is the document stack thicker than
10mm?
Reduce the number of sheets in the document
sheet to 10 mm thickness or less.
Is the Pad ASSY dirty? Clean the Pad ASSY. Refer to Operator's Guide
in "3.2. Cleaning the ADF".
Is the Pad ASSY worn out? Replace the Pad ASSY. Refer to Operator's
Guide in "4.2. Replacing the Pad ASSY".
Paper is not fed (pick error
occurs frequently, or docu-
ment stops midway).
Do the documents qualify the "Docu-
ment Quality" and the "Double-feed
Detection Conditions" in the chapter 6
of the fi-4530C Operator’s Guide?
Use the documents that qualify the "Document
Quality" and the "Double-feed Detection Con-
ditions" in the chapter 6 of the fi-4530C Opera-
tor’s Guide.
Is the Pick roller dirty? Clean the Pick roller. Refer to Operator's Guide
in "3.2. Cleaning the ADF".
Is the Pick roller worn out? Clean the Pick roller. Refer to Operator's Guide
in "4.3. Replacing the Pick Roller".
Is there any debris on the document
feed path?
Remove any debris from the document feed
path.
Are the scanned images
elongated?
Are the Feed rollers dirty? Clean the Feed rollers. Refer to Operator's
Guide in "3.2. Cleaning the ADF".
Have you adjusted the scan scale? For Windows 98, Windows Me, Windows
2000, WindowsXP, select "Scanners and Cam-
eras" in the control panel, then click the [Device
Set] tab to adjust scale.
For Windows 95, Windows NT 4.0, right click
the Scanner Control Center in the task tray,
select [Options] and adjust the scan scale.
Is there a shadow on the
leading edge of the
scanned image?
Are the Feed rollers dirty? Clean the Feed rollers. Refer to Operator's
Guide in "3.2. Cleaning the ADF".
Adjust the offset. For Windows 98, Windows Me, Windows
2000, WindowsXP, adjust the [Sub-scan Set-
ting] on [Scanners and Cameras] in the control
panel.
For Windows 95, Windows NT 4.0, right click
the Scanner Control Center, select [Options]-
[Sub-scan Setting] and adjust the offset.
Symptom Check this item Remedy
