A SERVICE OF

logo

Open as PDF
next previous
5-2
Component Testing (continued)
Component Testing Chart
To Enter Manual Conguration Mode:
NOTE: This menu is accessible only during the
rstminutesafterthecooktopispluggedin.
1. Remove the key-lock functionality by
pressing the Control Lock button.
2. Press the following keys sequentially
(a beep will sound after each key
press): Timer “-”, Timer “+”, Timer“-”,
Timer“+”, Control Lock. After the key
stroke combination is pressed, a “CO”
will appear on the display.
3. Press the Control Lock button. A
“OO” will appear on the display.
4. Congurethecooktopbychoosing 
one of the following numbers, see
chart.
5. Press the Control Lock button to
 conrmtheconguration.The
 congurationwillthenbedownloaded
into the cooktop. This process will last
 afewseconds.Theconguration
number chosen will blink on the display.
6. The cooktop is ready to use.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
5
egatloV stluseRstniop kcehCpotkooc eht no noitacoL
zH06- CAV 042 ot CAV802 morF)N( )L( - 1Jdraob retlif IME
Power control board (PC) from Filter
(EMI) Board
Left and right
zH06- CAV 042 ot CAV802 morF)N( )L( - 1J
Power control board (PC) to blower fan
Left and right
J205 - (00) - (22)
J205 - (00) - (60)
From 0VDC to 12VDC
Power control board (PC) to coil sensor
Left and right
J604 - (1) - (2)
J605 - (1) - (2)
+5VDC
0V
+10.5V
Power control board (PC) to the User
Interface
J806 - 00
J806 - 88
J8
06 - 99
J806 - 22
J806 - 44
J806 - 99
[0VDC, Neutral pin])
0VDC
From 0VDC to 12VDC
Use the Timer buttons to scroll between the
numbers on the display, moving sequentially
and beginning at “00.” The Timer“+” button
will increase the number by 1, and the
Timer“-” will decrease the number by one.
Reconguration Chart
Conguraon Number
Cooktop Model