Connecting the AC Power Cord
12
m PARALLEL REMOTE terminal (modular
connector, 8-pin)
Connects a parallel switch and controls the monitor
externally.
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
modular connector.
For details on the pin assignment and factory setting
function assigned to each pin, see “Pin assignment” on
page 27.
n SERIAL REMOTE (RS-232C) terminal (D-Sub
9 pin)
Connects to the RS-232C control connector on external
equipment connected to the monitor. The monitor can
be operated according to control commands sent from
external equipment connected to it.
For details on the pin assignment and function assigned
to each pin, see “Pin assignment” on page 27.
For details, refer to the Interface Manual for
Programmers (saved in the supplied CD-ROM,
Japanese and English only).
Connecting the AC
Power Cord
Connect the supplied AC power cord as illustrated.
Two kinds of AC plug holders are supplied with this
unit. Use the AC plug holder that fits the AC power cord
most securely.
1
Plug the AC power cord into the AC IN socket on
the AC adaptor. Then, attach the AC plug holder to
the AC power cord.
2
Slide the AC plug holder over the cord until it locks.
AC power cord
AC IN socket
AC plug holder (Supplied)
