Filter
Top Products
74 Chapter 4
IDE Drive 0 Error
IDE Drive 1 Error
IDE Drive 2 Error
IDE Drive 3 Error
1. Enter BIOS Setup and load the default settings.
2. Check IDE drive jumper.
3. IDE hard disk drive power.
4. IDE hard disk drive cable/connection.
5. IDE hard disk drive.
IRQ Setting Error
Expansion ROM Allocation Fail
I/O Resource Conflict(s)
Memory Resource Conflict(s)
1. Load default settings in Setup.
2. Enter BIOS Setup and set the
Reset Resource
Assignments
of the
PnP/PCI Options
to Yes,
then reboot the system.
3. Remove all adapter cards that are NOT factory-
installed, then reboot the system
PCI Device Error 1. Load default settings in Setup.
2. Enter BIOS Setup and set the
Reset Resource
Assignments
of the
PnP/PCI Options
to Yes,
then reboot the system.
3. Remove all adapter cards that are NOT factory-
installed, then reboot the system.
PS/2 Pointing Device Interface Error
PS/2 Pointing Device Error
1. Re-connect PS/2 keyboard and mouse.
2. Enter BIOS Setup and load the default settings.
3. PS/2 mouse
4. PS/2 keyboard
5. System board
DMI Table Was Destroyed 1. Flash BIOS
Press
Ctrl
+
Alt
+
Esc
key to enter Setup or F1 key to
continue
1. Press
Ctrl+Alt+Del
to enter Setup and reconfigure the
system.
Press
Esc
to turn off NMI, or any key to reboot 1. Press
Esc
to reject NMI error or press any other key to
reboot the system.
Insert system diskette and press <Enter> key to
reboot
1. Insert a bootable disk into the floppy disk drive or
remove this disk if a hard disk is installed.
BIOS Messages Action/FRU