Filter
Top Products
Hardware Setup and Configuration 2
Agilent N8201A Performance Downconverter Synthetic Instrument Module, 3 Hz to 26.5 GHz 31
(Optional) Connect to a LAN with a Cross-Over LAN Cable
If you wish to communicate directly between the N8201A performance downconverter and
your PC without the use of a LAN hub, you can connect directly to your PC.
1 Connect a cross-over LAN cable from the LAN connector on your PC to the LAN
connector on the rear panel of the N8201A performance downconverter.
2 Turn on power to the PC.
3 Turn on power to the N8201A performance downconverter and wait until the LAN LED
turns solid green or until you hear an attenuator click from within the
N8201A performance downconverter; this can take up to four minutes depending on
whether the instrument is using DHCP or Auto IP.