Filter
Top Products
4
Installing a New G700 without an S8300
Configure the G700
Installation and Upgrades for G700 and S8300 183
December 2003
Assign the IP Addresses of the G700 Media
Gateway Components
Tip:
The Avaya Gateway Installation Wizard (GIW) performs this task automatically.
This section describes how to assign the IP addresses and IP routes to the G700 Media Gateway and its
components. The IP addresses should be available to you on the IP Addressing Planning Form. The
command arguments you will be supplying include:
Access the P330 stack processor
1 Set up a direct connection to the G700 Console (serial) port and access the P330 stack processor
using Hyperterm (or similar terminal emulation application).
2 Login as root.
Assign the IP address to the P330 stack processor
1 At the P330-1(configure)# prompt, type
set interface inband
<vlan> <ip_address> <netmask> to assign an IP address to the
P330 stack processor.<vlan> is the vlan number, usually 1, to be established on the S8300 for the
G700 Media Gateways. The <ip_address> <netmask> is the assigned addresses for the P330
stack processor.
2 Type reset and press Enter to reset the stack.
3 Select Yes at the dialog box that asks if you want to continue.
All LEDs will flash. As the unit powers up, self-tests will be run. When the G700 mpg or P330
stack processor has reset, login again to continue.
4 Login at the Welcome to P330 menu.
The prompt
P330-1(super)# appears.
5 Type configure to obtain the P330-1(configure)# prompt.
vlan –Virtual Local Area Network: a defined network segment that allows
users on that segment to have priority services in sharing information
with each other.
If the network is not using VLANs, the VLAN should be 1. Otherwise,
use the VLAN numbers indicated in your planning forms. The G700
Media Gateway should be assigned the same VLAN as the VLAN to
which the Ethernet ports are connected. The P330 stack processor might
or might not be assigned to the customer’s network management VLAN.
IP address –the unique identifier assigned to an entity on the customer LAN
netmask –the subnet mask for the customer’s LAN segment
destination –distant networks that the IP route command needs to send packets to.
Usually generalized to 0.0.0.0 for networks other than the local segment.
default gateway –the gateway the ip route command specifies to get to the distant
networks