Filter
Top Products
4
Installing a New G700 without an S8300
Install New Firmware on the G700 Media Gateway
Installation and Upgrades for G700 and S8300 195
December 2003
Example: Show mgp bootimage
4 At the MG-???-1(configure)# prompt, type
copy tftp mgp-image <bank> <filename> <tftp_server_ip_address>
to transfer the mgp image from the tftp server to the G700, where
<bank> is the bank that is not Active Now (Bank A in the example).
<filename> is the full path name of the mgp firmware image file, which begins with mgp and will
be similar to the name mgp_8_0.bin.
<tftp_server_ip_address> is the IP address of the S8300. See the following example:
copy tftp mgp-image a mgp_8_0.bin 195.123.49.54.
The screen will show the progress.
5 Type set mgp bootimage <bank> where <bank> is the same letter you entered in the previous
step.
6 At the MG-???-1(configure)# prompt, type reset mgp.
A system prompt asks to confirm the reset.
7 Select Yes at the dialog box that asks if you want to continue.
The G700 Media Gateway processor will reset. The LEDs on the G700 Media Gateway and the
Media Modules will flash. These elements will each conduct a series of self-tests. When the LEDs
on the Media Modules are extinguished and the active status LEDs on the G700 Media Gateway
are on, the reset is complete.
8 When the P330-1(super)# prompt appears, type session mgp.
9 At the MGP-???-1(super)# prompt, type configure.
10 Verify that the download was successful when the prompt returns.
Type
show mg list_config. The system displays the list of software.
FLASH MEMORY IMAGE VERSION
Bank A 109
Bank B 210
ACTIVE NOW
ACTIVE AFTER REBOOT
Bank B Bank B