Filter
Top Products
5
Upgrading an Existing G700 with an S8300 — R1.x to R2.0
Upgrade the Firmware on the G700
Installation and Upgrades for G700 and S8300 255
December 2003
3 At the MG-001-1(super)# prompt, type configure to change to the configuration mode.
4 Type copy tftp mm-image v<slot #> <filename mm> <tftp_server_ip_address>
where <slot #> is the slot of the specific media module as identified when you performed
Determine Which Firmware to Install on the G700
,
<filename mm> the full-path name of the media module firmware file in a format such
mm712v58.fdl, and
<tftp_server_ip_address> is the ip address of the S8300.
Two or three minutes will be required for most upgrades. The VoIP Media Module upgrade takes
approximately 5 minutes. Screen messages indicate when the transfer is complete.
5 After you have upgraded all the media modules, verify that the new versions are present. At the
MG-???-1(configure)# prompt, type
show mg list_config
The list of software appears
Show MG List_Config
6 In the TYPE column, find the particular media module (v1 through v4), then check the matching
field in the FW VINTAGE column to see if it matches the planning documentation. Note that slot
V1 can contain either a media module or the S8300, which will show as Type "ICC".
7 Check the VOIP FW column and row for slot v0 to see if the number matches the VoIP firmware
identified in the planning documentation.
8 Type reset <module #> where <module #> is the number of the G700 in the stack.
9 When the reset is finished, type show mm to verify the upgrade.
Release board (if media module was busied out)
1 When the upgrade procedure is complete, go to the SAT session and release the board:
type
release board vx where x is the slot number of the upgraded media module.
2 Verify the response, Command Successfully Completed.
NOTE:
If you see the response, Board Not Inserted, this means that the media module is still
rebooting. Wait one minute and repeat the
release board command.
3 Repeat the release board command for each media module that was busied out.
SLOT TYPE CODE SUFFIX HW VINTAGE FW VINTAGE VOIP FW
---- ------ ----- ------ ---------- ---------- -------
V0 G700 DAF1 A 00 230(A) 67
V1 ICC S8300 A 72 00 N/A
V2 DCP MM712 A 2 58 N/A
V3 ANA MM711 A 2 57 N/A
V4 DS1 MM710 A 1 58 N/A