Filter
Top Products
11
Chapter 2 Operating the EB1304 MOB
2.1 Using the EB1304 MOB for the First Time
For the fist time using the DVR unit, suggest user connect with the monitor and setup
DVR unit by OSD menu. Once the DVR unit has been set up, user can use LED panel
with remote control to modify setup of DVR unit.
2.1.1 Select the Setup Mode and Video System
Before starting setup the DVR unit, please select the setup mode and video system.
DVR unit has two setup modes – OSD and LED mode. By adjusting switch, user can
change the setup mode. The following figure shows the setup mode switch setting.
.
ON
1
2
3
ON
1
2
3
OSD
LED
VGA
TV
NTSC
OSD
VGA
NTSC
PAL
LED
TV
PAL
OSD Mode LED Mode
The DVR unit supports two system types – NTSC and PAL. Please select the correct
video system before power on the unit.
Before set up the DVR unit, please make sure the setup mode that is the
one user wants to use. Otherwise, the DVR unit won’t be able to receive
remote control signal correctly.
2.1.2 Formatting Hard Disk
Upon connecting the power, the unit automatically detects the status of the hard disk.
The hard disk must be formatted for the first time using with DVR unit. If you are
prompt to format the hard disk, press (select) for
YES
to format the hard disk
and (menu) for
NO
to remain unchanged.
HARD DISKS INFORMATION
VERSION A4 2 . 1 . 1 . 01
HDD
HDD FORMAT YES (SELECT) / NO (MENU)
HDD CHECKING . . .
SIZE 18GB 495MB