Filter
Top Products
5
1.5 Setting Up the DVR Unit
1.5.1 Installing the Hard Disk
The DVR unit allows you to install one hard disk. Before installing the hard disk, make
sure to set the hard disk master/slave jumper setting. Adjust the jumper setting
according to the instructions on the hard disk label. Please set the jumper of hard disk
as Master. Follow the illustrated instructions below to install the hard disk:
1. Using key to unlock the hard disk key
lock
2. Pull removable hard disk drawer out
3. Connect the power connector to the
hard disk (master)
4. Connect the IDE cable to hard disk
5. Turn the drawer over and secure the
hard disk with 4 screws on the hard
disk removable drawer
6. Slide the drawer back
7. Using key to lock the hard disk key
lock
8. You may now connect all the cables.
When the power is connected, the
Power LED light
turns on
i
- Use 40GB/ 7200RPM IDE hard disk or larger is recommended.
- The DVR unit support hard disk hot swap. Therefore, user can swap the
hard disk without shutdown the DVR unit.