BenQ H200:A Flat Panel Television User Manual


 
User’s manual
Connections 17
Note:
1. Component video is the best type of signal that can be used. The most common sources that use
Component outputs are DVD players, and it is highly recommended that Component be used when
possible. Component video goes one step beyond S-Video in picture quality. All HDTV signals must be
input into this port. It may also be used for other high-resolution signals such as progressive DVD
players or computers.
2. Connect the output of a progressive DVD Player to Component Input (Y Pb Pr).
3. Connect the output of a standard DVD Player to the Component Input (Y Cb Cr).
4. We can support 480p, 720p and 1080i HDTV signal.
How to connect the PC Input Terminals
RGB signal (min D-SUB 15 pin) connection
Example of input signal source
PC-D-Sub
PCorNotebook
Connect the D-sub signal terminal on the TV to
the output of PC equipment through min D-sub
15 pin cable as illustrated.
Connect a cable, which matches the audio output
terminal on the computer.
Note:
1. The display native resolution is 800 x 600. If the signal resolution exceeds the native resolution,
it may not be possible to show fine detail with sufficient clarity.
2. An adapter is required to use the PC cable (D-sub 15P) to connect a Macintosh computer to
the set.
3. Some PC models cannot be connected to the set.
4. There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminals.
5. The computer shown in the illustration is for example purposes only.
6. Additional equipment and cables shown are not supplied with this set
7. Do not set the horizontal and vertical scanning frequencies for PC signals, which are above or
below the specified frequency range.
8. For more information about external device connec
t
ions, see the manuals of your external
devices.