Filter
Top Products
Model AC1120A, AC1121A, AC1122A, AC1123A
14
3.1.3 Recalling Presets (routing patterns)
The number of presets accessible from front panel is the same as # of inputs
(however through the IP or Serial port, the unit can store and recall up to 16
presets even for an 8 input Model)
Press and release the Preset button. The button will light up solid. Then press and
release the input button (it will light up) and hit ENTER. You have 8 seconds to
hit ENTER or the action will be cancelled. This will recall the desired preset tie
pattern.
Note that a recalled preset replaces the current tie configuration, which will be
lost unless it has been stored as another preset.
3.1.4 Saving Presets (routing patterns)
The current tie configuration can be saved as a preset to be called up later on.
To save the current AV routing pattern, press and hold the PRESET button for 3
sec, the backlit LED will start flashing (this means that save preset function has
been activated). Press the desired input button to save the preset (the button with
light up). Then hit the ENTER button to complete the operation. Again, you have
8 seconds to complete this sequence.
3.1.5 Disconnecting all AV outputs (blank preset)
There is a hidden blank preset (think of it as Preset #0) in the system that can be
very useful in clearing all ties. A blank preset is a preset without any ties selected
in it. To Recall a blank preset, press and release the Preset button, press and hold
the ARROW UP (▲) button, and simultaneously press the ARROW DOWN (▼)
button. This will clear all ties. From here, the user can make new ties or save the
blank tie over a preset that had ties in it which effectively erases that preset.
3.1.6 To reset system to factory defaults
Disconnect the AC power from the unit. Press and hold the ENTER button on the
front panel while plugging in AC power. Continue to hold the ENTER button
until all LEDs on the front panel flash on. System reset clears all ties, presets,
schedule settings, and unit name.
3.1.7 Using the Front Panel VU meter
This function is useful for ensuring no noticeable volume difference among the
audio sources for models AC1121A and AC1123A.
Press and hold the AUD button for approximately 3 seconds until the backlit LED
starts to blink. Press and release an input button whose audio you want to adjust.