Filter
Top Products
PROTOCOL CONVERTER MODEL A/S-4
26
NOTE
Selection of a blank programmable VDU type may cause erroneous command
characters to be sent to the operators VDU. The programmable VDU type should be
added by option 3 before it is selected.
3. Add or Change Name - by entering a 3 the operator is able to add a name to or change a
name from the “PROGRAMMABLE” column see figure 4. This is done when the operator’s
VDU does not match one of the “FIXED” VDU’s and it allows him to define to the A/S-4 the
various commands his VDU needs to operate properly (e.g., the command from the A/S-4
which will cause his VDU to clear the screen). In the example shown in figure 4, the operator
has given the name “NEW VDU” to VDU A. Operator input is underlined. The 10 characters
are filled out with spaces or just type carriage return. By typing the letter “H”, he has copied
the characteristics of VDU H into those of “NEW VDU”. The “CURRENT” header will now
show the VDU as “NEW VDU”. Using the VDU commands menu (selection C on the Main
Menu) he can now change the clear screen command (or any other command) from the
command copied from VDU H to whatever “NEW VDU” needs (these commands may be
found in the NEW VDU manual).
4. Delete Name - By entering a 4 the operator can delete a name from the “PROGRAMMABLE”
VDU list.
Enter Number: 3 Enter Letter A
Enter A 10 Character Name: NEW VDU
Make New NEW VDU Name Look like established Name: (Enter Letter) H
CURRENT:
Application = SDLC/SNA 3274/76 Interactive
VDU = NEW VDU
Keyboard = Standard
Change: VDU
1 or A-Exit
2-Change Current Name
3-Add or Change Name
4-Delete
PROGRAMMABLE: FIXED
A-NEW VDU F-IBM 3101; DEC VT52
B- G-ANSI STD; DEC VT100; Teletype 5410, 5420; Televideo 970, 960
C- H-Televideo 910 thru 950; Zwntec Zepher
D- I-Lear Siegler AND 3A
E- J-IBM PC 3270
Figure 4