Filter
Top Products
PROTOCOL CONVERTER MODEL A/S-4
50
The Verify Switch Settings menu allows 2 operations as described below:
A. Exit - By entering the letter A the A/S-4 will return to the Main Menu.
B. Restart With New Switch Options - When a B is typed and he A/S-4 will start over, just like the
power has been turned off and then on. When the A/S-4 goes through power up, all switches
displayed in the menu will be read and serviced.
The Verify Switch Settings menu will display any change in the switches in the menu. The change in the
switch should be followed by the Restart command B to insure that the change has been acted upon.
NOTE
The Verify Switch Settings menu will be displayed when running with the A/S-4 PC
card, but the switches have no effect on the program running in the PC card because
there are no switches on the PC card, so the values displayed for the switches is actual
data read from the PC memory.
6.14 Reload Default Options
By selecting item K from the main menu (Section 6.3), the operator obtains the screen shown in Figure
19 which in turn can change all the options in the A/S-4 to their defaults. Entering any character other
than a “Y” will return to the main menu without changing any options, if a “Y” is entered the A/S-4 will
go through its power up routine as if the power to the unit was turned off and then on.
Reload Default Options
If sure type Y (ALL PAST WORK WILL BE LOST!)
Figure 19
Refer to section 8.4 of Batch operation for the A/S-4’s default options settings.