Filter
Top Products
Chapter 4 Web Admin interface
LinkStation User Manual 143
Name Descriptions
Maintenance
Email
Notication
Click [Modify
Settings]
to change
settings.
Click [Send
Test Message]
to send a test
e-mail to the
e-mail address
which has
been set.
Notication Select whether using E-mail notication feature or not. Following
message is sent by using E-mail Notication.
Note: Mail Server displays the list of [POP before SMTP] (the method to
give the permission to use SMTP server by authenticating at specied
POP server before sending e-mail). If this is set, this feature cannot be
used.
SMTP Server
Address
Enter [SMTP Server Address] (Mail Server Address).
SMTP Port No. Enter [SMTP Port No.].
Authentication Type Select [Authentication Type] from [POP before SMTP], [LOGIN(SMTP-
AUTH)], and [CRAM-MD5(SMTP-AUTH/CRAM-MD5)].
POP3 Server
Address
Enter the [POP3 Server Address] (E-mail server address).
POP3 Port No. Enter [POP Port No.].
SSL/TLS When [LOGIN(SMTP-AUTH)] and [CRAM-MD5(SMTP-AUTH/CRAM-
MD5)] are selected for [Authentication Type], specify either using [SSL]
or [TLS].
Username Enter a user name that will be used for authentication.
Password Enter the password used to access with above user name.
Subject Specify the subject of the e-mail to be sent. Use only one-byte
characters, not two-byte characters.
Recipient(s) Enter the e-mail address of the receiver, and click [Add]. You can
register up to 5 e-mail addresses as receivers.
Report Select the contents to send in the e-mail notication.
• [
HDD Status Report]
Send the status other hard drive of the LinkStation on the specied
time on [HDD Status Sending Time].
• [Fan Failure]
Sent if a problem on the fan of the LinkStation.
• [Disk Error]
Sent when an error occurs on the drive.
• [Backup Complete]
When the backup job is completed
Sent if the backup of the LinkStation is completed.
Maintenance
Restart
LinkStation
Restart the
LinkStation
Click [Restart] to reboot the LinkStation.