Filter
Top Products
LinkStation User Manual 168
Appendix
The Info/Error LED blinks red to indicate an error.
The error may be identied by the pattern of blinking.
Note: The error may also be viewed from NAS Navigator2.
Error code Descriptions
E00 MPU is abnormal; no power. Contact Bualo tech support for assistance.
E01 DRAM data line is abnormal. Contact Bualo tech support for assistance.
E02 DRAM address line is abnormal. Contact Bualo tech support for assistance.
E03 RTC chip is abnormal. Contact Bualo tech support for assistance.
E04 Kernel extraction failed. Contact Bualo tech support for assistance.
E14 The RAID array cannot be mounted. Turn o power, then turn power on again.
If the same error is displayed, re-congure RAID. And if the same error is displayed again, contact
Bualo tech support for assistance.
E15 Hard drive I/O error. Contact Bualo tech support for assistance.
E16 The hard drive is not connected, or data transfer has failed. Check your hard drive status. If the error
still remains, contact Bualo tech support for assistance.
E17 Controller error. Contact Bualo tech support for assistance.
E21 Controller error. Contact Bualo tech support for assistance.
E23 The hard drive has crashed. Contact Bualo tech support for assistance.
Place Status
10s place The LED illuminates for 1 second every 0.3 seconds.
The number of ashes is the tens place of the error code.
1s place The LED illuminates for 0.5 seconds every 0.3 seconds.
The number of ashes is the ones place of the error code.
Power LED
Status Descriptions
Solid Blue The LinkStation is powered on.
Blinking blue The LinkStation is starting up or shutting down.
O The LinkStation is o.