Filter
Top Products
Chapter 4 Web Admin interface
LinkStation User Manual 144
Power Management
UPS Settings
Click [Modify Settings]
to change settings.
Synchronization
with UPS
[synchronize with UPS connected to this LinkStation]:
Select to synchronize the LinkStation with a UPS that is directly
connected.
[synchronize with UPS connected to other LinkStation on the
network]:
Select to synchronize the LinkStation with a UPS that is
connected to a dierent LinkStation on the same network.
[do not synchronize with UPS]:
Select if synchronizing to a UPS is not desired.
synchronized
source LinkStation
IP Address
If [synchronize with UPS connected to other LinkStation on the
network] is selected, enter the IP address of the LinkStation that
is directly connected to the UPS.
UPS Connection
Type
Select a connection method with UPS.
Note: [USB Port (APC Style)] or [USB Port (OMRON Style)] can be
only set when UPS manufactured by APC for USB connection is
connected.
LinkStation
behavior When
Power failure
Allows you to set the time until shutdown when the power
failure continues. Or, it can shut down when it detects "Battery
Low" from UPS.
Note: “Low Battery” shutdown is only supported with UPSs that
are connected to the LinkStation via USB.
UPS Behavior After
LinkStation has shut
down
Specify whether or not to shut down the UPS after shutting
down the LinkStation.
SleepTimer
Click [Modify Settings]
to change settings.
Timer Interval Select Sleep Timer interval from [Disable], [Everyday], or [Specic
day of the week]. If selecting [Specic day of the week], specify
the day by clicking the check box of the day. Timer can be set
from 1 - 3.
Wake up at Specify a wake-up time for the LinkStation to recover from sleep
mode and resume its normal state. Times from 0:00 to 23:45 are
allowed.
Begin Sleep at Specify a time for the LinkStation to move from its normal
functionality to a standby state (“sleep mode”). Times from 0:00
to 27:45 are allowed.
Note: The wake-up time must be later than the beginning time.