Filter
Top Products
21
DV30
ENGLISH
SCART/Component
Note:HDMI output must be set to ‘Off’ for this menu to be accessible. Select between
the following choices:
Component-p– Enables progressive scan component (YPbPr) using the 3 phono/RCA
component outputs on the rear panel.
Component-i – Enables interlaced scan component (YCbCr) using the three phono/
RCA component outputs on the rear panel.
SCART RGB – Enables interlaced scan RGB + Sync using the SCART/Peritel output on
the rear panel.
Note:Not all TV sets can accept Progressive Scan Component and a blank screen may
result if the set does not support this format.
For Component-p, the component outputs will be 480p if the TV type has been set to
NTSC, or 576p if the TV type has been set to PAL. Similarly for Component-i, the
component outputs will 480i if the TV type has been set to NTSC, or 576i if the TV
type has been set to PAL. If the Auto setting is used the format will follow the disc type.
Note:
• The Composite (CVBS) and S-Video outputs are always present and always output
interlaced video, whether Component, RGB or HDMI is selected.
• Setting HDMI output to ‘On’ by selecting an output resolution disables the TV type
and SCART/Component menus and, in fact, always forces the component outputs
‘On’ in component-p (Progressive Scan) format.
• With HDMI output ‘On’, all analogue video outputs will output PAL if a 50Hz HDMI
mode is selected, or will output NTSC if a 60Hz HDMI mode is selected.
• With HDMI output ‘Off’, all analogue video outputs follow the TV type for their PAL/
NTSC mode choice.
HDMI Setup
The default setting is ‘Enabled’. The default resolution is 720p (50Hz) for PAL, or 720p
(60Hz) for NTSC. Should you wish to change the resolution, select the one you desire:
576p (50Hz) Progressive format PAL
720p (50Hz) Upscaled to PAL at 720 lines progressive
1080i (50Hz) Upscaled to PAL at 1080 lines interlaced
1080p (50Hz) upscaled to PAL at 1080 lines progressive
480p (60Hz) Progressive format NTSC
720p (60Hz) Upscaled to NTSC at 720 lines progressive
1080i (60Hz) Upscaled to NTSC at 1080 lines interlaced
1080p (60Hz) upscaled to NTSC at 1080 lines progressive
Note:Selecting a 50Hz format will automatically cause the TV Type menu item to show
PAL. Selecting a 60Hz format will automatically cause the TV Type menu item to show
NTSC.
Important! If you select an HDMI resolution that your TV does not support, you may
lose the picture. In this case you may need to make an analogue video connection to
your TV to be able to see the picture again and select another resolution in the Setup
menu.