Filter
Top Products
9
DV30
ENGLISH
SCART RGB
Use a SCART/Peritel cable to connect to the 21-pin SCART input jack of a TV. SCART
carries both audio (stereo) and video (as either Composite or RGB) at the same time.
With SCART RGB enabled, RGB and composite signals are output simultaneously via
the SCART socket. Your television will automatically select RGB (the better quality
signal) if it is able to support this signal. If you are having difficulty in obtaining an
RGB picture on your TV screen or want to check which SCART socket of your TV is
suitable, please consult your television manual.
Note:If RGB output via SCART is desired, then HDMI output must be set to ‘Off’ (HDMI
Resolution option) and SCART RGB must be selected instead of Component output
(Scart/Component option) in the Video Setup Menu.
Trigger In
The DV30 can be turned on and off (i.e. brought in and out of Standby mode) by the
presence of 5-12V DC at the Trigger input. The matching Sonata AR30 or DR30 2.1
receivers have a suitable output which provides such a trigger allowing them to
automatically turn the DV30 on or off as required.
Digital Outputs
Digital audio outputs can be used to connect to a suitable Audio/Video Receiver for
surround sound decoding (output must be set for ‘RAW Bitstream’ – refer to the Audio
Setup section). These outputs can also be used to connect to a separate DAC or digital
recording device (output must be set for ‘PCM Stereo’ – see Audio Setup section).
Note: The HDMI output can also carry surround sound or stereo audio (as well as
video). See the Audio Setup Menus section on page 23 for details.
Toslink Optical – Use a high quality TOSLINK fibre optic cable.
S/P DIF Co-axial Digital – Use a high quality 75 ohm digital RCA/Phono interconnect
cable designed specifically for digital audio use.
Important: To achieve the best results, we always recommend using high quality
Cambridge Audio leads which carry a lifetime guarantee.
5
6
7
Important Note
This unit has been designed to play video DVDs, compact discs,
recordable CDs (CD-R) and rewritable CDs (CD-RW) bearing the
identification logos shown here. No other discs can be used.
The CD-R/CD-RW discs should contain properly recorded TOC
(Table of Contents) information so that they can be played back.
This unit can play only the discs recorded in the CD-DA format
designed for music reproduction. Do not attempt to play a disc
containing other data, such as a CD-ROM for PCs with mp3 or
WMA files, on this unit.
2.1 Channel Audio Out
These sockets provide 2.1 output, i.e. stereo plus sub. They can be used to connect
to the 2.1 audio line-level inputs of an amplifier, AV receiver or amplified speaker
package as required.
8