Filter
Top Products
10
Instruction Manual Plasma Display Electric Pop-Up Lift
INSTALL THE DISPLAY ON THE LIFT
Attach Brackets to the Display
1. Follow the instructions accompanying the PSB brackets
designed for your display.
Mount the Display
1. Remove 4 screws and slide back panel cover up and out (see
Figure 11).
2. Make sure the latch on the mount is lowered to the side before
attempting to place the display on the mount (see Figure 12).
3. With the aid of another person, lift the display up to the mount,
aligning the PSB mounting buttons on the display with the
teardrop slots on the mount, and set the plasma into place.
CAUTION: If the latch does not travel to the full upright position,
remove and reset the display.
4. While supporting the display, raise the latch.
5. Install Q-clamp (see Figure 13).
6. Install back panel cover and secure using 4 screws.
Raise Latch to Secure Display
Tear Drop Slots
Latc
h
Lowere
d
Figure 12. Latch and Tear Drop Slots
Figure 11. Back Panel Cover Removal
Remove screws
Figure 13. Install Q-clamp
Q-clamp