Chief Manufacturing 8805-000009 TV Mount User Manual


 
8
Instruction Manual Plasma Display Electric Pop-Up Lift
4. With the extended position finish piece and the plasma-
mounted, lower the unit to its fully retracted position.
5. Place the side pieces in position (do not attach).
6. Place the top piece in position (do not attach).
7. Measure the distance from the top surface of the top piece to
the top surface of your furniture and cut this dimension from
each side piece (see Figure 8).
8. Remove and assemble finish pieces (bottom, sides and top),
making sure your finished box is square.
CAUTION: A backing is recommended for support. Frame move-
ment could result in damage to the frame, damage to the lift, and
damage to the plasma.
CAUTION: Check plasma ventilation requirements. Provide ven-
tillation for your application.
9. Measure box, construct a backing for lateral support, and
install backing.
WARNNG: Be aware during the installation that this is a
motorized device, and there are pinch points for people and for
electrical wiring. Keep hands and electrical wiring away from
internal components of the mechanism
CAUTION: Failure to allow clearance for the finish pieces to
retract to the fully lowered position may result
in damage to the finish pieces, damage to the
lift, and damage to the plasma.
10. Carefully, without plasma mounted on
lift, operate lift to ensure the finish pieces
have sufficient clearance during full travel
and that top finish piece is flush with the furniture top when
fully retracted.
Figure 8. Side Piece Dimensions
Furniture
Finish Piece
Plasma
Backing
Retracted Position
Finish Piece
Finish Piece
Extendeded Position
Side Pieces
Figure 7. Retracted Position Finish Piece