Filter
Top Products
Installation Instructions PNR Series
13
Swing Arm Tension Adjustment
Swing arm tension is pre-set at the factory and is adjusted to
accommodate displays with weights near the top of the mount’s
capacity.
If smaller displays are used it may be difficult to reposition the
display after mounting.
NOTE: The display must be mounted prior to adjusting swing
arm tension.
To adjust swing arm tension to compensate for smaller display:
1. Place adjustment insert (F) into tension adjustment screw
located at swing arm pivot point. (See Figure 15)
NOTE: The display may need to be repositioned in order to
gain access to the tension adjustment screw(s).
2. Use the adjustment wrench (E) provided with the mount,
turn adjustment insert clockwise to increase swing arm
tension (See Figure 16) or counterclockwise to reduce
swing arm tension. (See Figure 17)
NOTE: Small adjustments of 1/8 turn or less are typically all
that is required to achieve desired tension.
3. Check swing arm tension. If desired tension is present,
tension adjustment is complete. If additional tension
adjustment is required, repeat steps 1 and 2 until desired
tension is achieved.
NOTE: If changing from a smaller display to a larger display it
may be necessary to increase swing arm tension.
Figure 15
Figure 16
Figure 17
Tension adjustment
screw
(E)
(F)
Increase tension
Reduce tension