Filter
Top Products
Installation Instructions PNR Series
9
Mounting the Display
WARNING: IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY
OR DAMAGE TO EQUIPMENT. Displays can weigh in
excess of 40 lbs (18.1kg). ALWAYS use two people and
proper lifting techniques when installing display.
1. Install PSBU interface bracket (K - included with PNRU
only) to display using hardware and installation instructions
included with PSBU bracket.
2. Move faceplate to extended position by grasping faceplate
and pulling outward away from wall.
WARNING: IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY
OR DAMAGE TO EQUIPMENT. Make sure mounting buttons
on display are properly seated in mounting holes in faceplate.
3. While supporting both sides of display, align four mounting
buttons on display or interface bracket with four mounting
holes in faceplate. (See Figure 6) and (See Figure 7)
4. Lower display into place listening for audible "click" to
ensure recessed area of mounting buttons are properly
seated in lower area of mounting holes and ClickConnect
mechanism engages. (See Figure 6) and (See Figure 7)
NOTE: Holes are provided in the faceplate for use with a
padlock or similar locking device, if desired. In addition,
the pin and nut may be removed from the upper holes
and moved to the lower holes for use as a more
permanent locking device. (See Figure 7)
Figure 6
Figure 7
3
4
4
3
To use as a
more permanent
lock, remove pin
and nuts and move
to lower holes.
A padlock or bolt may be
placed through latch holes.