Filter
Top Products
Installation Instructions PNR Series
7
Installing Mount to Wall
WARNING: IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s
responsibility to make sure the structure to which the mount
is being installed is capable of supporting five times the
combined weight of the mount and all attachments.
NOTE: The following instructions assume a suitable mounting
structure and surface exists prior to installation.
CAUTION: To avoid personal injury, use an assistant when
lifting, lowering or holding PNR during installation.
1. Determine mounting location taking into consideration
display size and PNR’s range of movement.
2. Using a stud sensor locate two wood studs 16” on center.
(See Figure 1)
Figure 1
3. Place and level mount against wall, aligning mounting holes
in upper and lower wall channels with studs. (See Figure 2)
4. Mark four mounting holes making sure mounting holes are
located as close as possible to center of studs.
(See Figure 2)
5. Drill four 7/32" pilot holes where the mounting holes were
marked. (See Figure 2)
Figure 2
Wood Studs
(Wall)
Pilot
Holes
16"
1
3
4
5
x 4
3