Filter
Top Products
RECORDING
43
Thanks to this programming system, you no longer
need to tediously enter the date, programme
number, start and end time. All the information
needed by the HDD/DVD Recorder for programming
is contained in the VideoPlus programming number.
This VideoPlus number is found in most TV listings.
1
Insert recordable media such as DVD±R,
DVD±RW if you are recording to DVD.
2
Press [TIMER].
The ‘Select Record Method’ menu appears.
3
Select ‘VideoPlus’ with [
…
/
†
] and confirm with
[ENTER].
The ‘VideoPlus’ menu appears.
Enter the entire ‘VideoPlus’ number. This
number is up to 9 digits long and can be found
next to the start time of the TV programme in
your TV listings magazine.
e.g.: 5-234-89 or 5 234 89
Enter 523489 for the ‘VideoPlus’ number.
If you make a mistake, you can clear it with
[CLEAR].
4
Press [ENTER] to confirm.
Timer Recording using VideoPlus
system
4
Enter the necessary information for your Timer
Recording(s).
•
œ √
– Moves the cursor left/right.
•
…† – Changes the setting of the current
cursor position.
• Press [SETUP] to exit the Timer Record menu.
• Press [ENTER] after filling in all the program
information.
• Press [TIMER] to display the Timer Record List.
5
Press [ENTER] to save the program.
The Timer Record List will appear.
6
Press [SETUP] to exit the Timer Record List.
7
Timer indicator will light or start blinking. You
must power off the HDD/DVD Recorder to start
the Timer Recording.
finishes to confirm the recorded program. If
two timer recordings are set to record
sequentially (one right after the other), the very
beginning of the later program may not be
recorded.
Timer Recording
Edit Timer
Media
PR No. PR-03
Date 02/Jan Sun
Start 13:30
End 14:30
Mode HQ
Repeat Once
Delete
Instructions:
Enter-Save Setup-Exit
Timer Recording
PR No. Date Start End Mode
PR-03 02/01 13:30 14:30 HQ
---- --/-- --:-- --:-- ---
---- --/-- --:-- --:-- ---
Select Record Method
Please choose your preferred
method for scheduling
Manual edit timer
VideoPlus
Instructions:
Enter-Confirm Setup-Exit Move …†
VideoPlus
Please enter your VideoPlus Code.
– – – – – – – – –
• The Timer indicator lights on the front panel
display when the HDD/DVD Recorder is ready
for the Timer Recording.
• The timer indicator will flash if any of the
following conditions occur;
- Empty or non-recordable disc is found in the
tray when DVD Timer recording starts.
- When you go into Media browser, SETUP,
Timer Recording menu after Timer Recording
setup.
- When you record the TV signal after Timer
Recording setup.
- When you play titles after Timer Recording
setup.
• The HDD/DVD Recorder will automatically
power off when the Timer Recording ends.
• There is a short delay when a timer recording
DG-M22-12D1P-XA(GB) 2005.12.22 8:4 AM ˘ ` 43 mac001 1200DPI 100LPI