Filter
Top Products
44
5
The decoded information appears after
confirmation. You can go back at any time to
change the information by pressing [ENTER].
Select the appropriate input field using [
…†].
If required, change the information using
[
…†].
If all the information is correct, press the
[ENTER] button. The programming information
is stored in a TIMER block.
6
Press [SETUP] to exit the Timer Record List.
7
Timer indicator will light or start blinking. You
must power off the HDD/DVD Recorder to start
the Timer Recording.
Timer Recording
PR No. Date Start End Mode
PR-03 02/01 13:30 14:30 HQ
---- --/-- --:-- --:-- ---
---- --/-- --:-- --:-- ---
---- --/-- --:-- --:-- ---
---- --/-- --:-- --:-- ---
---- --/-- --:-- --:-- ---
---- --/-- --:-- --:-- ---
---- --/-- --:-- --:-- ---
Instructions:
Enter-Edit Setup-Exit Move …†
Edit Timer
Media
PR No. PR-03
Date 02/Jan Sun
Start 13:30
End 14:30
Mode HQ
Repeat Once
Delete
Instructions:
Enter-Save Setup-Exit
VideoPlus is not available for some countries.
You can clear a Timer Recording any time before
the recording actually starts.
• Use [
…†] to select the program you want to
erase on the Timer Recorder List, then press
[ENTER] to modify it. Use [
œ √] to select
'Delete' then press [ENTER].
Or just press [CLEAR] on the Timer Recorder
List.
Canceling a Timer Recording
After a Timer Recording has started, you can still
cancel the program by pressing and holding [STOP]
for 5 seconds.
Stopping a Timer Recording in
Progress
Even if a Timer Recording is set, the HDD/DVD
Recorder will not record if:
• No disc is loaded.
• A non-recordable disc is loaded.
• ‘Lock Disc’ is set to ON in the DISC Settings
menu; see page 54.
• There are already 49 titles recorded on the disc
or 254 titles recorded on the HDD.
You cannot enter a Timer Recording if:
• A recording (dubbing, copying) or playing titles
is already under way.
• The start time has already passed.
• Eight Timer Recordings have already been set.
If two or more Timer Recordings overlap:
• The earlier program takes priority.
• When the earlier program finishes, the later
program starts.
• If two programs are set to start at exactly the
same time, the program entered first takes
priority.
Confirmation is not possible when:
• The DISC Lock setting is set to ON.
• There are already 49 titles recorded on the disc
or 254 titles recorded on the HDD.
If the disc is damaged, the recording may not
complete successfully, even if the Check field
shows ‘Rec. OK‘.
Timer Recording Troubleshooting
Recording Priority
• Timer Recording and OTR (One Touch Record)
have the same priority but they have lower
priority than manual recording. During manual
recording, Timer Recording or OTR will be
ignored.
The cooling fan continues to work when a Timer
recording is set and VPS/PDC is turned ON,
because the HDD/DVD Recorder has to get time
data from the station.
Timer Recording
DG-M22-12D1P-XA(GB) 2005.12.22 8:4 AM ˘ ` 44 mac001 1200DPI 100LPI