Filter
Top Products
26
Q9. Why do some recorded CD-R/W discs have mosaic video or overlay video
effect after a few erase and re-write cycles?
It’s because the erase operation was not completed; you may double erase the
disc in VDR-3000 to resolve the problem.
Q10. What is the right setting for Power MAC G4 or iMAC to output video to VDR-
1000/3000DV for producing Video CD disc?
a). Require MAC O.S. 9.0.4 and QuickTime V4.1.2 for Power MAC G4 or iMAC
b). Please use the Final Cut Pro or iMovie software utility in the G4 for video capture
b). To disable the "remote function" in the Apple fire wire device control and treat the
VDR-1000DV interface as a video capture card, which means you need to "click"
on capture video manually as soon as the video is showing on the screen.
c). Online Un-plug the VDR-1000/3000DV fire wire cable from the G4 and re-plug it
back again to initialize the cable link and the G4 will find the correct protocol to
work with VDR-1000/3000DV.
Q11. Why am I getting the error message "Vencmpeg did not start"?
The VDR-3000 needs to have a signal to synchronize to before it records.
This error message is usually given when a user enables recording on the
VDR-3000 before playing back source material. When recording from
DV(IEEE/1394) you must play your source before pressing record on the
VDR-3000. Running 10 seconds of black should allow for a smooth recording
entry.
Q12. Why isn't the DV input working?
When connecting to your unit make sure that you have switched the
selector switch in the back of the VDR-3000 to "DV". Once the DV
selector switch is changed to DV, a red led will appear on the front
panel of the VDR-3000. Play your source video and watch to see
that the video is appearing on your monitor.
Q13. Why doesn't the S-video input work?
If you want to record from an S-video input source the selector button
on the remote control must be pressed when the unit is powered up.
On the lower right corner of the remote control there is a button marked
"I/P" this is the button that must be pressed. The default input for video
is composite (RCA type connectors) if you don't change the input the
S-video input will roll and the video signal will not pass through.
Q14. Why doesn't the CD-R disc that was written by the VDR-3000
play back in my home DVD player?
Not all consumer dvd players are compatible with the VCD or SVCD
formats. Some consumer dvd players are unable to read CD-R and
CD-RW discs.