Filter
Top Products
116 Installing System Components
Figure 3-23. Storage Controller Card Cabling (Four 3.5-inch Hard Drive Chassis)
RAID Battery
The information in this section applies only to systems with the optional
PERC controller card.
Removing a RAID Battery
1
Pull back gently on the right edge of the battery bay and draw out the
RAID battery from the battery carrier.
2
Disconnect the cable between the RAID battery and the storage controller
card. See Figure 3-24.
1 RAID battery (PERC only) 2 SAS A connector on backplane
3 cable retention bracket 4 integrated storage controller card
5 SAS_0 connector 6 RAID battery connector (PERC only)
3
2
4
1
5
6