Dell R710 TV Cables User Manual


 
44 About Your System
Memory odd/even
logic failure at
address,
read
value
expecting
value
Faulty or improperly
installed memory modules.
See "Troubleshooting System
Memory."
Memory
write/read
failure at
address
, read
value
expecting
value
Faulty or improperly
installed memory modules.
See "Troubleshooting System
Memory."
Memory set to
minimum
frequency.
The memory frequency may
be intentionally set lower for
power conservation.
If not an intentional setting,
check any other system
messages for possible causes.
The current memory
configuration may support
only the minimum
frequency.
Ensure that your memory
configuration supports the
higher frequency. See
"General Memory Module
Installation Guidelines."
Memory tests
terminated by
keystroke.
POST memory test was
terminated by pressing the
spacebar.
Information only.
MEMTEST lane
failure
detected on
x
Invalid memory
configuration. A
mismatched memory
module is installed.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines."
Mirror mode
disabled. For
mirror mode,
DIMMs must be
installed in
pairs. Pairs must
be matched in
size and
geometry.
The memory configuration
does not match the setting
in BIOS. The BIOS setting
has been disabled.
Reconfigure the memory
modules for Memory
Mirroring mode. See "System
Memory."
Table 1-2. System Messages (continued)
Message Causes Corrective Actions