Dell R710 TV Cables User Manual


 
About Your System 43
Local keyboard
may not work
because all user
accessible USB
ports are
disabled. If
operating
locally, power
cycle the system
and enter system
setup program to
change settings.
The USB ports are disabled
in the system BIOS.
Power down and restart the
system from the power
button, and then enter the
System Setup program to
enable the USB port(s). See
"Entering the System Setup
Program."
Manufacturing
mode detected
System is in manufacturing
mode.
Reboot to take the system
out of manufacturing mode.
Maximum rank
count exceeded.
The following
DIMM has been
disabled:
x
Invalid memory
configuration. The system
will run but with the
specified memory module
disabled.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines."
Memory address
line failure at
address
, read
value
expecting
value
Faulty or improperly
installed memory modules.
See "Troubleshooting System
Memory."
Memory double
word logic
failure at
address
, read
value
expecting
value
Faulty or improperly
installed memory modules.
See "Troubleshooting System
Memory."
Memory
Initialization
Warning: Memory
size may be
reduced
Invalid memory
configuration. The system
will run but with less
memory than is physically
available.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines."
Table 1-2. System Messages (continued)
Message Causes Corrective Actions