Filter
Top Products
27
ENGLISH
3
w When “96k LPCM OUT” is selected:
Use the 5 and ∞ cursor buttons to select the conversion mode,
press the ENTER button to decide.
96k (Factory default)
When playing linear PCM DVDs that are not copyright-protected,
for 2-channel PCM audio signals up to 96 kHz, linear PCM signals
are output as such without being converted from the digital
outputs.
PCM signals of 48 kHz/16 bits and lower are output, regardless of
whether they are copyright-protected or not.
For DVDs containing multi-channel PCM signals, the digital signals
are down-mixed for output into two channels, front left and right.
(Only the front left and right channels are output for sources for
which down-mixing is prohibited.)
When playing copyright-protected linear PCM DVDs, in
consideration of copyrights, no digital signals are output for
sources exceeding 48 kHz/16 bits. When playing such sources,
either set to “96k>48k” or make analog connections. (See page
10.)
96k>48k
Linear PCM and packed PCM signals are converted to 44.1 kHz
or 48 kHz and output. (The PCM digital audio output signals are
converted to 48 kHz or less in consideration of copyrights.) When
making digital connections to an AV amplifier that is not compatible
with 96 kHz/88.2 kHz signals, set to “96k>48k”.
When playing DVDs recorded in linear PCM or packed PCM
and the unit is set to output digital and analog audio signals
simultaneously, the analog audio output signals are also converted
to 48 kHz or below, so we recommend setting to “96k” and also
making analog connections.
e When “DYNAMIC RANGE” is selected:
Use the 5 and ∞ cursor buttons to select the “ON” or “OFF”,
press the ENTER button to decide.
MAX (Factory default)
Dynamic range control is not operating. You can hear the original
audio.
MID
Dynamic range control operates at the mid-level. The size
difference between sounds becomes a little smaller.
MIN
Dynamic range control operates at the maximum level. The size
difference between sounds is reduced to the smallest level.
Remote control unit
ENTER
Remote control unit
w
DIGITAL OUTPUT PCM
96k
MAX
SET: ENTER BUTTON
96K LPCM OUT
SET 96k LPCM OUT
SELECT:
DYNAMIC RANGE
AUDIO SETUP
e
DIGITAL OUTPUT PCM
96k
MAX
SET: ENTER BUTTON
96K LPCM OUT
SET DYNAMIC RANGE
SELECT:
DYNAMIC RANGE
AUDIO SETUP
✽ To exit the setup mode
Press the SETUP button.