Filter
Top Products
20
ENGLISH
System Call Function
The RC-8000 is equipped with a system call function for emitting a series of remote control signals by pressing a
single button.
This function can be used for example to turn on the power of the amplifier, switch the amplifier’s input source, turn
on the power of a monitor TV, turn on the power of a DVD player, and set the DVD player to the play mode – all at
the touch of a single button.
[1] System call buttons
There are 20 system call buttons.
Remote control signals for a maximum of 10 operations can be stored at each button.
[2] Storing system call signals
The following explanation uses the procedure of actually registering the following system call signals as an
example.
Settings: Turn on AV amplifier power
Switch AV amplifier input to DVD
Turn on DVD player power
Set DVD player to play mode
q Press “SETUP” on the icon display section for 3
seconds to display the setup screen.
Press the “Sys. Call Setup” button on the
“Setup 3/4” page to display the system call
selection screen.
w Press the “Add” button on the system call
selection screen to set the mode for inputting
buttons to be registered in the system call
setting.
e Select the buttons whose signals you want to
store at a system call button.
The device registered at the top of the icon
display section is displayed first. (By default, AV
amplifier page 1 is displayed.)
Here, press the AV amplifier “ON” button and
the “DVD” button.
To select other devices, press the JOG
switch’s ENTER button to display the icon
display section, then select the device.
Screen q
Screen w
Screen e