Filter
Top Products
28
ENGLISH
[4] Registering device names
Use the procedure described below to register
names, etc., for registered devices.
q Press “SETUP” in the icon display section for at
least 3 seconds to display the setup screen.
Press the “Device Label” button on the “Setup
1/4” page to display the device selection screen.
w Use the and buttons in the icon
display section to display the icon for the device
for which you want to register a device name,
etc., then press that icon.
e Input the device name, etc.
“_” (under bar) is displayed at the left edge. The
place where this is displayed can be edited.
For instructions on inputting the device name,
etc., refer to section “Inputting button names”
on page 19.
Once the device name, etc., has been input,
press the “OK” button to register that device
name.
Registered device names are displayed as shown below.
Up to 16 characters can be input for device names.
Screen q
Screen w
Screen e
Device name