Filter
Top Products
5
ENGLISH
5
OPERATION
About the RF Transmission Function
RF transmission is possible when the RC-8001ST is used in combination with the RC-8000 (included with the AVR-
5800 or sold separately) remote control transmitter.
With this function it is possible to operate your components from another room in your home, or to operate your
components if they are in an enclosed cabinet not conveniently nearby, etc.
Procedure for RF Transmission
To conduct RF transmission, change the setting of the RC-8000 remote control transmitter to RF using the procedure
described below.
q Press the “SETUP” icon in the icon display section
for at least 3 seconds to display the setup screen.
Press the “RF/IR Select” button on the “Setup 4/4”
page to display the RF/IR selection screen.
w Use the and buttons on the device name
list to display the device for which you want to
perform RF transmission.
Press the icon for that device to switch the setting
from IR to RF.
Press the “OK” button to complete the setting and
return to the setup screen.
The setting switches between RF and IR each time
the button is pressed while it is displayed with a half-
tone dot mesh.
At the setup screen, press the icon for the device set to RF to display the remote
control signal transmission screen and perform RF transmission.
RF Transmission Frequency
Interference may cause operation to be unstable when conducting RF transmission.
In such cases, change the RF transmission frequency.
When changing the RF transmission frequency, set the RC-8001ST and the RC-8000 remote control transmitter to
the same position (RF 1 or 2).
OK Cancel
SETUP
RF/IR Select
AVAMP
Select RF or IR
VCR
TV
TUNER
DVD
RF
IR
RF
RF
IR
Screen q
Screen w
RC-8000 RC-8001ST
RF1• •2
RF1• •2