Filter
Top Products
16
© 2006 Directed Electronics
constant (+)12 volts. Locate the suspected wire using the
www.designtech-intl.com Web site and place the red lead of the
test probe on the suspected wire. With the key in the off position
the probes LED will be off. Turn the key to the on position and
the LED tester will illuminate Red. Now watching your probe,
turn the key to the crank position. If the LED extinguishes this
is not an ignition wire but an accessory wire. If the wire tests
correctly, solder the thick PINK (4) wire of the heavy gauge wires
to it and wrap the connection with electrical tape.
If the vehicle requires more than one ignition as per the Web site
information follow the same test procedure and solder the thick
PINK/WHITE (6) wire of the heavy gauge wires to it and wrap
the connection with electrical tape. If your vehicle has only 1
ignition source, secure the PINK/WHITE out of the way.
If your vehicle requires more than two ignitions, an additional
relay (not provided) is required. Refer to the diagram below.