47
© 2006 Directed Electronics
step 11
Testing the system
Once steps 1-10 have been completed, the operation of the
system can be tested.
Ensure that the two 30-amp fuses are in the relay harness RED
wire fuse holders. Make sure that the vehicle is in park with the
emergency brake on and the hood closed. Press once on the
remote to initiate the remote start function. The parking lights
should flash to confirm the remote start command has been
received, The accessories and ignition should turn on followed
by the starter cranking and the vehicle engine running (this may
take a moment to initiate). Pressing once again on the
remote will shut the engine off.
This completes the testing, if all functions do not work correctly
check your wiring against the manual and verify all connections.
If you still experience problems contact Directed Technical
Support at
11--880000--447777--11338822
.
PROG
PROG
ARM
ARM
DISARM
DISARM
PROG
PROG
ARM
ARM
DISARM
DISARM
note: If power has been removed or the fuses removed,
the remote(s) will have to again be learned to the system.
➜