19
© 2006 Directed Electronics
wire. With the key in the off position the LED tester should be
extinguished in all key positions except the crank position. In
the crank position your LED tester should illuminate Red, and
will extinguish when the starter disengages.
Once you locate the starter wire, cut the wire in half (
cchheecckk tthhee
wweebb iinnffoorrmmaattiioonn bbeeffoorree ccuuttttiinngg
) and try to start the vehicle. If
the vehicle does not start, the correct wire has been identified.
Reconnect both ends the starter wire while soldering the thick
VIOLET (1) wire of the heavy gauge wires to it and wrap the
connection with electrical tape.
Many Nissan vehicles have two starter wires. A relay (not provided)
is required to hook up the additional starter wire. Refer to the
diagram below.
nnoottee::
Always check the Web site information on your
vehicle for warnings regarding the starter wire and check
engine lights. Some vehicles will trip a check engine light
if the starter wire is cut.