Filter
Top Products
SEARCHING FOR YOUR CODE
If your TV,VCR, DIRECTV® Receiver,or auxiliary device
does not respond to the DIRECTV Universal Remote
Control after trying all of the codes listed for your brand,
or if your brand is not listed at all, try searching for
your code.
For example, to search for a code for your TV:
1. Turn on your TV.
2. On the DIRECTV Universal Remote Control,
press TV once. Then press and hold Setup until
the TV key blinks twice, then release Setup.
3. Enter 9 - 9 - 1.The TV key will blink twice.
4. Aim the remote control at the TV and slowly
alternate between pressing Power and TV.
Stop when the TV turns off.
NOTE: In the search mode,the DIRECTV Universal
Remote Control will send IR codes from its library to
the selected device,starting with the most popular
code first.
5. Press Setup once to lock in the code.
6. To search for the codes of your other devices,
repeat steps 1 through 5, but substitute the
appropriate key (i.e.,VCR,AUX,or SAT) for the
device you are searching for.
23
DirecTV Mnl MDTV6 3/21/03 2:04 PM Page 23