Filter
Top Products
24
CHECKING THE CODES
If you have set up the DIRECTV® Universal Remote
Control using the Searching For Your Code procedure (on
the previous page),you may need to find out which four-
digit code is operating your equipment.For example,to
find out which code is operating your TV:
1. Turn on your TV.
2. On the DIRECTV Universal Remote Control,
press TV once. Then press and hold Setup until
the TV key blinks twice, then release Setup.
3. Enter 9 - 9 - 0.
4. To view the code for the first digit,press 1 once.
Wait 3 seconds and count the number of LED
blinks (e.g.,3 blinks = 3) and write down
the number in the leftmost TV Code box on
page 12.
NOTE: If a code digit is “0”, the LED will not blink.
5. Repeat step 4 three more times for remaining
digits.Use 2 for the second digit,3 for the third
digit, and 4 for the fourth digit.Finish writing
down the code in the TV Code boxes (on
page 12).
6. To check for other device codes,repeat steps 1 to
5,but substitute the appropriate key (i.e.,VCR,
AUX,or SAT) for the device you are checking.
Write down the codes in the appropriate boxes
on pages 10 and 12.
DirecTV Mnl MDTV6 3/21/03 2:04 PM Page 24